
Bosch · Part number HR6DPP33V · NZ$67.00 incl. GST
Needing new spark plugs for your Ford Focus or Mazda 3? These BOSCH spark plugs deliver the zap to get your engine firing properly, giving you better performance and fuel economy.
NZ$67.00 including GST. Part number HR6DPP33V.
Spark Plug Change-Out: Get Your Ford Focus or Mazda 3 Humming Again!
> Spark plugs are the unsung heroes in your Ford Focus or Mazda 3's engine, igniting the fuel-air mix. Over time, they get gunked up and worn out, leading to misfires and a rough ride. Time for a swap!
Spotting the Signs of Dodgy Spark Plugs
• Engine's misfiring, especially when you put your foot down
• Idling like a tractor
• Fuel bills suddenly higher than a cafe lunch
• Engine's a pain to start in the mornings
• That pesky check engine light's lit up
WOF Worries?
Failing spark plugs can cause your car to pump out excessive emissions, which will lead to a WOF failure faster than you can say 'failed inspection'.
DIY or Workshop?
Difficulty: 6/10
Estimated Time: 1-2 hours
Tools Required: Spark plug socket, ratchet, torque wrench, extension, spark plug gap tool.
🛠️ Bob's "Get It Done Right" Companion Checklist
Before diving in, make sure you're prepped like a pro. Safety first, always! Grab yourself some safety glasses to keep the grit out of your eyes, and a pair of nitrile gloves to keep those hands clean. A can of Brake Cleaner is perfect for blasting away any carbon buildup around the spark plug holes. A tiny dab of anti-seize on the new plug threads never hurts either.
Expert Recommendation
Swapping out your spark plugs in your Ford Focus or Mazda 3 is a no-brainer for boosting performance and saving fuel. Swing by Bob's Shop, and I'll help you find the perfect fit for your ride!
Fitment Notes
Getting the spark plug gap spot-on is crucial for your engine. Check your car's service manual for the recommended setting. Some Ford Focus and Mazda 3 models can be a bit fiddly to reach the plugs, so you might need some extra tools or to remove other parts to get in there. Bob's always here to lend advice.
Bob here from CARFIX, ready to help you get your ride sorted!
---
🛠️ Bob's Pro Tip: Do the Job Right!
> If you're replacing this spark plug, make sure you've got the right workshop prep, protection, and safety gear ready. Taking a bit of extra time and using the proper safety stands and cleaners makes all the difference for a professional result!
🧰 What Else You'll Need:
• Safety First: Always secure your vehicle on heavy-duty safety jack stands before working underneath. Never rely solely on a hydraulic jack.
• Clean Hands: Keep a pack of Nitrile Gloves handy to protect your skin from grease, oils, and chemical sprays.
• Preparation: Have microfibre towels and a suitable parts cleaner nearby to keep components clean during installation.