Toyota Corona Mark II 13T-U (1980–1984)

The TOYOTA CORONA MARK II Base was a popular choice for New Zealand families in the early 1980s, known for its reliability and affordability. This wiki aims to provide valuable information for current owners to help maintain and keep their Corona Mark II in good condition.

Parts for the Toyota Corona Mark II 13T-U

• Radiator Cap (10)
• Oil Filter (7)
• Fuel Filter (4)
• Welch / Frost Plug (3)
• Spark Plug (3)
• Head Set/Valve Regrind Gasket Set (3)
• Brake Shoe Rear (3)
• Wheel Nut (3)
• Rear Wiper Pack (2)
• Steering Idler Arm (2)
• Brake Pads Front (2)
• Drive Belt Alternator (2)
• Valve Cover Gasket (2)
• Oil Pressure Switch/Sender (2)
• Thermostat Housing Gasket (2)
• Bearing Clutch Release (2)
• Thermostat (2)
• Air Filter (2)
• Sump/Drain Plug (2)
• Oil Cap (2)
• Wiper Blade (2)
• Rear Single Blade (2)
• Suspension Bush Rear Shock Absorber - Lower (1)
• Manifold Gasket Exhaust (1)
• Manifold Gasket Inlet (1)
• Reverse Lamp Switch (1)
• Conversion Gasket Set (1)
• Conrod Bearing (1)
• Timing Chain (1)
• Piston Ring (1)
• Crankshaft Thrust Washer (1)
• Suspension Bush Shock Absorber (1)
• Wiper Blade Front & Rear (1)
• Bearing Clutch Spigot (1)
• Shocks / Strut (1)
• Passenger Side Blade (1)
• Sway Bar Coupling Mount (1)
• Temperature Sensor / Sender Coolant (1)
• Spark Plug Tube Seal (1)
• Wheel Bearing Grease Front (1)
• Tie Rod End (1)
• Ball Joint Front (1)
• Automatic Transmission Filter (1)
• Engine Oil (1)
• Wiper Refill Set Front (1)
• Disc Brake Rotor Front (1)
• Steering Arm (1)
• Switch Stop Light (1)
• Wheel Cylinder Rear (1)
• Bush (1)
• Wiper Refill Front (1)
• Wiper Blade Front (1)
• Front Wiper Pack (1)
• Oil Seal Crank Shaft Front / Timing Front (1)
• Oil Seal Crank Shaft Rear / Rear Main Bearing (1)
• Driver Side Blade (1)

Known issues

<H2>Common Problems and Solutions</H2>
Owners of TOYOTA CORONA MARK II Base vehicles in New Zealand may encounter certain common issues as the car ages. Addressing these proactively can help prevent more significant problems down the line.

<ul>
<li><b>Rust:</b> Rust is a prevalent issue, particularly in body panels. Regular inspections and rust prevention treatments can mitigate this.</li>
<li><b>Oil Leaks:</b> Keep an eye out for oil leaks from the engine. Addressing these promptly will prevent more serious mechanical issues.</li>
<li><b>Worn Suspension Bushings:</b> Over time, suspension bushings can wear out, affecting handling and ride comfort. Replacing worn bushings can restore the vehicle's original performance.</li>
</ul>
These issues often begin to appear around 150,000 to 250,000 kilometers.

WOF tips

<H2>WOF Watch Points</H2>
When taking your TOYOTA CORONA MARK II Base for a Warrant of Fitness (WOF) in New Zealand, be aware of these common areas of concern:

<ul>
<li><b>Rust in sills/floor:</b> Assessors will carefully inspect the sills and floor for rust, as this can compromise the vehicle's structural integrity.</li>
<li><b>Brake lines corrosion:</b> Corrosion on brake lines is a significant safety concern. Ensure brake lines are in good condition.</li>
<li><b>Headlight alignment:</b> Properly aligned headlights are essential for safe nighttime driving.</li>
</ul>

About the Toyota Corona Mark II 13T-U

<H2>Owning a TOYOTA CORONA MARK II Base in New Zealand</H2><p>The Toyota Corona Mark II holds a special place for many Kiwis who appreciate a practical and robust vehicle.</p>

<H3>Maintenance and Care</H3>
Proper maintenance is key to extending the life of your Corona Mark II. Regular servicing is crucial, paying attention to potential wear and tear on key components. Consider this guide a starting point for preventative measures.

<H3>Standard Fitment Considerations</H3>
<ul>
<li><b>Brakes:</b> Regularly inspecting and maintaining the braking system is essential for safety. Address any signs of wear or reduced performance promptly.</li>
<li><b>Filters:</b> Changing the engine oil and air filters at recommended intervals will contribute to optimal engine performance and longevity.</li>
<li><b>Suspension:</b> Inspecting the suspension components for wear and tear, especially bushings and shocks, helps ensure a comfortable and safe ride.</li>
</ul>

Questions owners ask

What are the most common WOF failure points for a TOYOTA CORONA MARK II 1980–1984 in New Zealand?

When taking your TOYOTA CORONA MARK II 1980–1984 for a WOF in New Zealand, pay close attention to rust in the sills and floor, as this can compromise structural integrity. Corrosion on brake lines is another significant safety concern, and proper headlight alignment is essential for safe nighttime driving.

Where can I get replacement suspension bushings for my TOYOTA CORONA MARK II 1980–1984 in NZ?

CARFIX stocks 95 SKUs for the TOYOTA CORONA MARK II 1980–1984. While specific suspension bushing availability can vary, it's a common wear item. You can check the CARFIX website or contact them directly to inquire about replacement suspension bushings and other suspension components.

What are the typical maintenance issues I should look out for with an older TOYOTA CORONA MARK II in New Zealand?

Owners of TOYOTA CORONA MARK II 1980–1984 vehicles in New Zealand commonly encounter rust, particularly in body panels. Oil leaks from the engine are also frequent, and worn suspension bushings can affect handling and ride comfort. These issues often appear between 150,000 and 250,000 kilometers.

How often should I service my TOYOTA CORONA MARK II 1980–1984?

The recommended service interval for your TOYOTA CORONA MARK II 1980–1984 is every 10,000km. Regular servicing is crucial for extending the life of your vehicle, paying attention to potential wear and tear on key components like brakes, filters, and suspension.

Are there any DIY guides available for maintaining my TOYOTA CORONA MARK II 1980–1984?

Yes, CARFIX has 7 DIY video guides available specifically for the TOYOTA CORONA MARK II 1980–1984. These guides can help you with common maintenance tasks and preventative measures.

What parts should I regularly inspect on my TOYOTA CORONA MARK II 1980–1984 to ensure safety and performance?

For your TOYOTA CORONA MARK II 1980–1984, regularly inspect and maintain the braking system, including brake lines, for any signs of wear or reduced performance. Change engine oil and air filters at recommended intervals for optimal engine performance. Also, inspect suspension components, especially bushings and shocks, for wear and tear to ensure a comfortable and safe ride.