Mitsubishi Gto 6G72 (DOHC 24V) Coupe 163kW (1996–2000)

Welcome to your go-to resource for the Mitsubishi GTO Base model. This Vehicle Wiki provides valuable information about maintenance needs and potential issues to help you keep your GTO running smoothly.

Parts for the Mitsubishi Gto 6G72 (DOHC 24V) Coupe 163kW

• Front Wiper Pack (29)
• Wiper Blade Front (20)
• Passenger Side Blade (19)
• Fuel Filter (19)
• Driver Side Blade (18)
• Rear Wiper Pack (13)
• Rear Single Blade (13)
• Oil Filter (9)
• Radiator Cap (8)
• Brake Pads Front (8)
• Brake Pads Rear (8)
• Clutch Kit (6)
• Timing Tensioner (6)
• Spark Plug (6)
• Wiper Refill (5)
• Oxygen Sensor (5)
• Thermo Fan Switch (5)
• Manifold Gasket Inlet (4)
• Air Filter (4)
• Oil Seal Crank Shaft Rear / Rear Main Bearing (4)
• Automatic Transmission Filter (4)
• Wiper Blade (4)
• Wiper Blade Front & Rear (4)
• Temperature Sensor / Sender Coolant (4)
• Steering Rack Boot Kit (4)
• Oil Cap (3)
• Clutch Slave Cylinder (3)
• Wheel Nut (3)
• Oil Seal Crank Shaft Front / Timing Front (3)
• Camber Bolt Kit Front (3)
• Timing Belt Idler (3)
• Tie Rod End (3)
• Harmonic Balancer (3)
• Switch Stop Light (3)
• Sway Bar Link Front (3)
• Oil Seal Camshaft End (3)
• Lash Adjuster (3)
• Wheel Bearing Kit/Hub Rear (3)
• Valve Cover Gasket (3)
• Suspension Bush Front Control Arm (3)
• Oil Pressure Switch/Sender (2)
• Thermostat (2)
• Water Pump (2)
• Steering Rack End (2)
• Drive Belt Power Steering (2)
• Sway Bar Link (2)
• Wheel Bearing Kit/Hub Front (2)
• Thermostat Housing Gasket (2)
• Suspension Bush Sway Bar Link (2)
• Suspension Bush Front Sway Bar Mount (2)
• Conrod Bearing (2)
• Oil Seal Camshaft (2)
• Ignition Module (2)
• Ignition Lead Set (2)
• Engine Oil (2)
• Cv Joint (2)
• Sump/Drain Plug (2)
• Ignition Coil (2)
• Alternator (2)
• Water Pump Gasket (2)

Known issues

While generally reliable, some owners of the Mitsubishi GTO Base model may experience issues such as oil leaks (valve cover gaskets, crankshaft and camshaft seals), and wear in suspension components. Regular inspection and proactive maintenance can help minimize these issues.

WOF tips

When preparing your Mitsubishi GTO for a Warrant of Fitness (WoF), ensure the following are in good working order: Windscreen wipers (front and rear), Brake lights (stop light switch functionality), Steering and suspension components (ball joint front), Reverse lights (reverse lamp switch functionality).

About the Mitsubishi Gto 6G72 (DOHC 24V) Coupe 163kW

{"Maintenance Matters":"Regular maintenance is crucial for preserving the performance and longevity of your Mitsubishi GTO. Key areas to focus on include: Replacing the oil filter at recommended intervals to ensure clean engine oil. Inspecting and potentially replacing drive belts, specifically the alternator belt, to prevent power loss or damage. Maintaining the valve cover bolt seals/washers to prevent oil leaks. Ensuring proper function of the reverse lamp switch for visibility and safety. Regular inspection and replacement of front and rear wiper blades (driver side, passenger side, rear blade) and refills for clear visibility in all weather conditions. Addressing oil leaks promptly by inspecting the oil seal crankshaft front / timing front and oil seal camshaft end.","Steering & Suspension":"Pay attention to the condition of your GTO's ball joints (front). Worn ball joints can affect handling and tire wear. It's recommended to visually inspect them during regular maintenance.","Braking System":"The functionality of your brake lights is essential for safety. Monitor the stop light switch and replace it if necessary to ensure that your brake lights illuminate properly when braking."}

Questions owners ask

What are some common issues to watch out for on a Mitsubishi GTO (1996-2000)?

Some Mitsubishi GTO owners have reported oil leaks around the valve cover gaskets, crankshaft seals, and camshaft seals. Also, keep an eye on the suspension components for wear. Regular inspections can help catch these issues early.

What should I check to prepare my 1996-2000 Mitsubishi GTO for a Warrant of Fitness (WoF) in NZ?

For your GTO's WoF, make sure your windscreen wipers (front and rear) are in good condition. Test your brake lights by checking the stop light switch functionality. Also, inspect the steering and suspension components, especially the front ball joints, and ensure the reverse lights are working correctly via the reverse lamp switch.

How often should I replace the oil filter on my Mitsubishi GTO?

It's recommended to replace the oil filter on your Mitsubishi GTO every 10,000km to ensure clean engine oil and optimal engine performance.

Where can I get a replacement alternator belt for my 1996-2000 Mitsubishi GTO in NZ?

CARFIX stocks a range of parts for the Mitsubishi GTO, including alternator belts. Check our website or visit a store near you to find the correct belt for your GTO.

My Mitsubishi GTO is leaking oil. What are the most likely causes?

Common oil leak sources on the Mitsubishi GTO include the valve cover bolt seals/washers, the oil seal crankshaft front / timing front, and the oil seal camshaft end. Inspect these areas first.

How often should I replace the wiper blades on my Mitsubishi GTO?

Replace your front (driver and passenger side) and rear wiper blades and refills as needed to maintain clear visibility, especially during the wet New Zealand winters. Check them regularly for wear and tear.

What kind of maintenance should I be doing regularly on my 1996-2000 Mitsubishi GTO to keep it running smoothly?

Regular maintenance for your GTO should include replacing the oil filter every 10,000km, inspecting and replacing drive belts (like the alternator belt) as needed, maintaining the valve cover bolt seals/washers to prevent oil leaks, and ensuring all your lights (brake lights, reverse lights) are functioning correctly.