Mitsubishi Eterna 4G32 Sedan (1984-1989) (1984–1989)

The MITSUBISHI ETERNA Base, a familiar sight on New Zealand roads, provided dependable and affordable transportation for many families. This vehicle wiki offers insights into maintaining your ETERNA Base, helping you keep it in top condition.

Parts for the Mitsubishi Eterna 4G32 Sedan (1984-1989)

• Radiator Cap (9)
• Oil Filter (5)
• Steering Rack Boot Kit (4)
• Wiper Blade Front (3)
• Front Wiper Refills (3)
• Air Filter (2)
• Fuel Filter (2)
• Drive Belt Alternator (2)
• Ball Joint Front (2)
• Steering Rack End (2)
• Oil Pressure Switch/Sender (2)
• Control Arm Front (2)
• Engine Mount Front (2)
• Timing Belt Camshaft (2)
• Wiper Blade (2)
• Cv Joint Boot Kit Front (2)
• Thermostat (2)
• Cv Joint (2)
• Starter Motor (1)
• Alternator (1)
• Engine Oil (1)
• Oil Cap (1)
• Front Wiper Pack (1)
• Wiper Blade Front & Rear (1)
• Passenger Side Blade (1)
• Wiper Blade Rear (1)
• Wiper Refill Set Front (1)
• Tie Rod End (1)
• Wiper Refill Front (1)
• Suspension Bush Front Control Arm - Lower (1)
• Wheel Bearing Kit/Hub Front (1)
• Wheel Bearing Kit/Hub Rear (1)
• Shocks / Strut (1)
• Bump Stop Rear (1)
• Switch Stop Light (1)
• Timing Tensioner (1)
• Thermostat Housing Gasket (1)
• Balance Shaft Tensioner (1)
• Bearing Clutch Release (1)
• Bearing Clutch Spigot (1)
• Cv Joint Boot Kit Front Left Inner (1)
• Cv Joint Boot Kit Front Right Inner (1)
• Cv Joint Boot Kit Front Left Outer (1)
• Cv Joint Boot Kit Front Right Outer (1)
• Temperature Sensor / Sender Coolant (1)
• Thermo Fan Switch (1)

Known issues

Like many vehicles of its age, the MITSUBISHI ETERNA Base can experience certain common issues as mileage increases. Owners have reported potential automatic transmission issues, the development of rust in vulnerable areas, and oil leaks potentially stemming from the valve cover gasket. These issues often surface around the 150,000 to 250,000 km mark. Addressing these proactively can help extend the vehicle's lifespan.

WOF tips

When preparing your MITSUBISHI ETERNA Base for its WOF (Warrant of Fitness), keep a close eye on areas known to be potential watch points. Pay particular attention to rust around the windscreen and rear arches, as well as the condition of the brake hoses. Addressing any corrosion promptly and ensuring brake hoses are in good repair boosts safety and helps the vehicle pass inspection.

About the Mitsubishi Eterna 4G32 Sedan (1984-1989)

As a practical and widely adopted vehicle in New Zealand, the MITSUBISHI ETERNA Base offered a blend of space and affordability. Owners often relied on its functionality for daily family needs.

Maintenance Matters: Regular servicing is vital for a long-lasting vehicle. Paying attention to filters, brakes, and suspension components will contribute to reliability.

Standard Fitment Considerations: Keeping the brakes, filters and suspension components in good order is important. Selecting standard NZ fitment parts designed for the ETERNA Base ensures compatibility and performance.

Remember to consult your owner’s manual for specific maintenance schedules and recommendations. Checking fluid levels regularly and adhering to a preventative maintenance plan can help avoid costly repairs down the road.

Questions owners ask

What are the common issues to look out for with a MITSUBISHI ETERNA 1984–1989 in New Zealand?

Owners of the MITSUBISHI ETERNA 1984–1989 often report potential automatic transmission issues, rust development in vulnerable areas like around the windscreen and rear arches, and oil leaks, particularly from the valve cover gasket. These issues tend to become more prevalent as the vehicle approaches the 150,000 to 250,000 km mark.

What should I check on my MITSUBISHI ETERNA 1984–1989 before its WOF inspection in NZ?

For your MITSUBISHI ETERNA 1984–1989's WOF, pay close attention to rust, especially around the windscreen and rear arches. Also, thoroughly inspect the condition of the brake hoses. Addressing any corrosion promptly and ensuring brake hoses are in good repair will significantly help with passing the inspection.

Where can I get standard NZ fitment brake pads for my MITSUBISHI ETERNA 1984–1989?

CARFIX stocks 67 SKUs for the MITSUBISHI ETERNA 1984–1989. You can find standard NZ fitment brake pads, filters, and suspension components designed specifically for your vehicle to ensure compatibility and optimal performance.

How often should I service my MITSUBISHI ETERNA 1984–1989?

The recommended service interval for your MITSUBISHI ETERNA 1984–1989 is every 10,000 km. Regular servicing, including checking filters, brakes, and suspension components, is crucial for maintaining its reliability and extending its lifespan.

What are some key maintenance tips for my MITSUBISHI ETERNA 1984–1989 to avoid costly repairs?

To avoid costly repairs on your MITSUBISHI ETERNA 1984–1989, regularly check fluid levels and adhere to the preventative maintenance plan outlined in your owner's manual. Proactively addressing common issues like potential oil leaks from the valve cover gasket and keeping brakes, filters, and suspension components in good order will contribute to its longevity.