The MITSUBISHI Base is often appreciated as a practical and dependable vehicle, particularly in rural New Zealand settings where its durability and readily available parts are valued. This guide provides helpful information for owners looking to maintain their Base and address potential issues.

Parts for the Mitsubishi 4G32 (?-2999) - Variant 1

• Engine Oil (19)
• Gear Oil Gearbox (12)
• Radiator Coolant (12)
• Axle Gear Oil (11)
• Automatic Transmission Fluid (10)
• Wiper Blade Front (7)
• Disc Brake Rotor Front (7)
• Power Steering Fluid (7)
• Suspension Bush Rear Leaf Spring - Shackle (6)
• Suspension Bush Front Sway Bar Mount (6)
• Leaf Spring Lowering Block (6)
• Suspension Bush Rear Leaf Spring - Rear Eye (4)
• Suspension Bush Rear Leaf Spring - Front Eye (4)
• Suspension Bush Radius Arm Front (4)
• Brake Fluid (4)
• Suspension Bush Set Rear Shock Absorber - Upper And Lower (4)
• Brake Pads Front (4)
• Tie Rod End (4)
• Starter Motor (3)
• Shocks / Strut Rear (3)
• Ball Joint Front (3)
• Steering Idler Arm (3)
• Steering Bush Steering Idler Front (3)
• Brake Drum Rear (3)
• Timing Tensioner (3)
• Radiator Hose (3)
• Suspension Bush Shock Absorber (2)
• Master Cylinder Kit Brake (2)
• Shocks / Strut Front (2)
• Clutch Kit (2)
• Water Pump (2)
• Temperature Sensor / Sender Coolant (2)
• Ball Joint Front Lower (2)
• Sump/Drain Plug (2)
• U Bolt Spring Rear (2)
• Suspension Bush Front Shock Absorber - Upper (2)
• Wheel Bearing Kit/Hub Front (1)
• Master Cylinder Brake (1)
• Spark Plug (1)
• Engine Oil Pan Gasket (1)
• Coil Spring Front Standard Profile (1)
• Timing Kit (1)
• Timing Belt Camshaft (1)
• Cylinder Head Gasket (1)
• Thermostat Housing Gasket (1)
• Alternator (1)
• Bearing Clutch Release (1)
• Universal Joint/Coupling Front & Rear (1)
• Clutch Slave Cylinder Kit (1)
• Suspension Bush Front Control Arm (1)
• Suspension Bush Leaf Spring (1)
• Suspension Bush Sway Bar Link (1)
• Tie Rod (1)
• Brake Caliper Kit Front (1)
• Brake Hose Front (1)
• Ball Joint Front Upper (1)
• Brake Shoe Rear (1)
• Switch Stop Light (1)
• Brake Pad Fitting Kit Front (1)
• Brake Shoe Fitting Kit Rear (1)

Known issues

MITSUBISHI Base owners should be aware of potential issues such as CV joint wear, distributor cap corrosion (especially in humid climates), and oil leaks from the rocker cover gasket. These problems are more commonly observed as the vehicle reaches higher mileage (150,000-250,000 km). Regular inspections and maintenance can help address these issues proactively.

WOF tips

During your Warrant of Fitness inspections, pay close attention to the condition of your MITSUBISHI Base's suspension bushes, especially those on the lower control arms. Also, check for any signs of rust, particularly around the windscreen and rear wheel arches.

About the Mitsubishi 4G32 (?-2999) - Variant 1

Owning a MITSUBISHI Base means understanding its common maintenance needs. Keeping up with these can help ensure its longevity.

Maintenance Considerations:
• Clutch System: Pay attention to the health of the clutch system (including the clutch kit and slave cylinder). Issues here can affect drivability.
• Steering & Suspension: Regularly inspect tie rods, idler arms, and suspension bushes (especially sway bar link and rear leaf spring eye) to maintain optimal handling. Consider leaf spring lowering blocks if desired.
• Drivetrain: Universal joints/couplings (front and rear) are critical for power transfer. Keep an eye on these.
• Fluid Checks: Ensure proper levels and timely replacement of automatic transmission fluid and power steering fluid.
• Engine Components: The timing belt, spark plugs, and coolant temperature sensor are vital for engine performance and fuel efficiency.

Potential Problem Areas:

Owners often report CV joint wear, distributor cap corrosion (particularly in humid environments), and oil leaks originating from the rocker cover gasket as the vehicle ages, typically around 150,000-250,000 km.

Questions owners ask

What are the most common issues I should look out for with my MITSUBISHI Base –2999 as it gets older?

As your MITSUBISHI Base –2999 approaches higher mileage, typically between 150,000-250,000 km, common issues include CV joint wear, corrosion of the distributor cap (especially in humid New Zealand climates), and oil leaks often originating from the rocker cover gasket. Regular inspections can help catch these early.

What should I pay extra attention to during my WOF inspection for my MITSUBISHI Base –2999?

For your MITSUBISHI Base –2999's Warrant of Fitness, it's crucial to inspect the condition of the suspension bushes, particularly those on the lower control arms. Additionally, check thoroughly for any signs of rust, especially around the windscreen and the rear wheel arches, as these are known problem areas.

Where can I get a new clutch kit or slave cylinder for my MITSUBISHI Base –2999 in NZ?

CARFIX stocks 219 SKUs for the MITSUBISHI Base –2999, so you can find a new clutch kit and slave cylinder directly from CARFIX. These parts are essential for maintaining the health of your clutch system and ensuring smooth drivability.

How often should I check the fluids in my MITSUBISHI Base –2999?

It's important to regularly check the levels and condition of your automatic transmission fluid and power steering fluid in your MITSUBISHI Base –2999. While the general service interval is 10,000km, fluid checks should be more frequent to ensure optimal performance and prevent wear.

What are the critical engine components I should monitor for my MITSUBISHI Base –2999?

For optimal engine performance and fuel efficiency in your MITSUBISHI Base –2999, pay close attention to the timing belt, spark plugs, and the coolant temperature sensor. These components are vital for the engine's operation and should be maintained according to the service schedule.

Can I install leaf spring lowering blocks on my MITSUBISHI Base –2999?

Yes, if you're looking to modify the stance of your MITSUBISHI Base –2999, leaf spring lowering blocks are an option. However, it's recommended to have a professional assess the impact on your suspension and handling.