CARFIX

Ryco SynTec Oil Filter Cartridge

Ryco Filters — Ryco SynTec Oil Filter Cartridge — part number R2720PST

Ryco Filters · Part number R2720PST · NZ$65.00 incl. GST

Ryco SynTec Oil Filter Cartridge by Ryco Filters, part number R2720PST.

Price

NZ$65.00 including GST. Part number R2720PST.

Fits these vehicles

Description

Oil Filter Change-Out: The CARFIX Way
> Oil filters are like the kidneys of your engine, especially in tough machines like the Ford Ranger and Mazda BT-50 that do a fair bit of towing or head off-road. They grab all those nasty bits that can score your engine and cause grief down the line.
What Clued You In?
• Oil pressure light flickerin' like a dodgy bulb.
• Engine makin' noises it shouldn't.
• Oil lookin' like mud rather than golden syrup.
• Your ute's not peppy like it used to be, and drinkin' more fuel.
WOF Worthy?
Yep, should be sweet as, long as there aren't any major leaks and it's bolted on properly.
DIY or Get a Pro?
Difficulty: A leisurely 4/10
Time Needed: Half an hour to an hour
Gear You'll Need: Oil filter wrench, socket set, drain pan, fresh oil, and some gloves.
🛠️ Bob's "Get It Done Right" Companion Checklist
Before you get stuck in, mate, a bit of prep goes a long way:
• Safety First, Eh? Never get under a vehicle supported only by a jack. Use proper axle stands – it's a no-brainer.
• Cleanliness Counts: Give the area around the filter a good wipe down before you start. Stops crud from getting into the engine.
• Protection: Chuck down an old sheet or some cardboard – oil spills are a pain to clean up.
• Lube It Up: Always smear a bit of fresh oil on the new filter's rubber seal. Helps it seat properly and stops leaks.
• Consumables: Grab a can of Engine Flush to clean out the engine before you drain the old oil. A bottle of Heavy Duty Hand Cleaner is also a lifesaver.
Expert Advice
Regular oil and filter changes are the best thing you can do for your Ford Ranger or VW Amarok, especially if you're always towing or hitting the trails. Pop into Bob's Shop and we can sort you out with exactly what you need!
Fitment Notes
Make sure you've got the right oil filter for your Ford Ranger, Everest, Mazda BT-50, or VW Amarok – engine types vary. And don't forget to grease that rubber gasket with fresh oil before you spin it on.

---

🛠️ Bob's Pro Tip: Do the Job Right!
> HPR05005)](/parts/HPR05005) to ensure a perfect bed-in and get the job done properly first time!

🧰 What Else You'll Need:
• Clean Workspace: Lay down an oil drip tray and microfibre towels under the oil drain plug.
• Gasket Inspection: Double check that the old oil filter's rubber O-ring came off with the filter, and pre-lube the new filter gasket with fresh oil before mounting.
• Clean Hands: Protect your hands from used engine oil with Nitrile Gloves.