NGK Spark Plugs · Part number PFR6N · NZ$49.00 incl. GST
NGK Iridium Double Fine Spark Plug by NGK Spark Plugs, part number PFR6N.
NZ$49.00 including GST. Part number PFR6N.
Subaru Legacy Spark Plug Replacement: Get That Engine Humming!
> Those little spark plugs in your Subaru Legacy and Legacy GT? They're working overtime under crazy heat and pressure. Over time, they get worn down and covered in carbon, causing misfires and costing you fuel. Time for a swap, eh?
Is Your Subaru Showing These Signs?
• Feeling some engine misfires, especially when you put your foot down?
• Idling rough as guts or stalling out?
• Not getting the k's per litre you used to?
• Having a heck of a time getting the engine started?
• That pesky check engine light on the dash?
WOF Worries?
Dodgy spark plugs mean extra emissions, and that's a surefire way to fail your WOF.
DIY or Call in the Experts?
Difficulty: 6/10
Time Needed: 1-2 hours
What You'll Need: Spark plug socket, ratchet, extension bar, torque wrench, spark plug gap tool
Expert Advice
Swapping out your spark plugs is a no-brainer for keeping your Subaru Legacy or Legacy GT running sweet.
🛠️ Bob's "Get It Done Right" Companion Checklist
Before you get cracking, grab these must-haves to make the job a breeze and keep things tidy:
• Safety First! Don't be a goose; always wear Safety Glasses to protect your peepers from flying grit and grime. And grab a pair of Nitrile Gloves to keep your hands clean. No one likes a mechanic with dirty mitts!
• Cleanliness is Key: Before you even *think* about pulling those old plugs, give the area a good spray with Brake Cleaner. This blasts away any grit that could fall into the cylinders once the plugs are out. Nasty!
• The Right Touch: When you're putting the new plugs in, a tiny dab of anti-seize on the threads is your mate. It'll make life easier next time you need to swap them. Just don't go overboard!
Fitment Notes
Make sure that spark plug gap is set right for your Subaru Legacy or Legacy GT. Check your owner's manual for the correct gap and torque settings.
Swing by Bob's Shop if you're stuck – always happy to lend a hand!
---
🛠️ Bob's Pro Tip: Do the Job Right!
> If you're replacing this spark plug, make sure you've got the right workshop prep, protection, and safety gear ready. Taking a bit of extra time and using the proper safety stands and cleaners makes all the difference for a professional result!
🧰 What Else You'll Need:
• Safety First: Always secure your vehicle on heavy-duty safety jack stands before working underneath. Never rely solely on a hydraulic jack.
• Clean Hands: Keep a pack of Nitrile Gloves handy to protect your skin from grease, oils, and chemical sprays.
• Preparation: Have microfibre towels and a suitable parts cleaner nearby to keep components clean during installation.