TRW · Part number GDB315 · NZ$117.00 incl. GST
Right, for those classic European workhorses like the Citroen C35 and Fiat 242, brake pads are your absolute lifesaver – they're the unsung heroes that turn all that forward oomph into stopping power, keeping you, your cargo, and everyone else on the road safe and sound.
NZ$117.00 including GST. Part number GDB315.
Brake Pad Replacement: Keep Those Old Vans Stopping Sweet!
> Alright team, let's talk brake pads – those crucial bits of magic that rub against your brake discs to get you pulled up sharp. On a classic beast like your Citroen C35 or Fiat 242, these pads really earn their keep, especially when you're hauling loads or navigating our hilly Kiwi roads. When they're worn out, your stopping power goes to custard, and that's just not on.
Symptoms That Led You Here
• Squealing or grinding noises when braking.
• Increased stopping distances.
• Vibration through the brake pedal.
• A spongy or soft brake pedal feel.
• Visible wear on the brake pads (less than 3mm of friction material remaining).
Will it pass WOF?
No, worn brake pads are a critical safety failure. Vehicles with brake pads below the manufacturer's minimum thickness (typically 1.5mm-3mm, but often visually obvious) or those causing excessive noise or poor braking performance will fail a New Zealand Warrant of Fitness (WOF).
DIY or Workshop?
Difficulty: 6/10
Estimated Time: 1-2 hours per axle
Tools Required: Jack, jack stands, wheel brace, spanner/socket set, C-clamp or brake caliper piston tool, brake cleaner, torque wrench, potentially a wire brush.
Expert Recommendation
Replacing brake pads is essential for maintaining the safety and performance of your vehicle, especially for classic vans like the Citroen C35 and Fiat 242 which may be carrying significant loads. Worn pads compromise stopping ability, putting occupants and other road users at risk. The TRW GDB315 brake pads are an excellent choice, known for their quality and consistent performance, suitable for the demands of these older commercial vehicles. Bob @ CARFIX is always on hand to help you work out exactly what part you need for your classic European van. Make sure you head over to Bob's Shop for a chat!
Fitment Notes
These brake pads are specifically designed for classic European commercial vehicles, including the CITROEN C35 (1973-1994), FIAT 242 D (1975-1980), FIAT 242 (1975-1982), FIAT 242 D (1980-1982), and CITROEN C35 D (1973-1980). Always double-check the specific year and model to ensure correct fitment, as variations can occur even within these ranges.
---
🛠️ Bob's Pro Tip: Do the Job Right!
> If you're swapping out these brake pads, don't skimp on proper workshop preparation and safety products. Doing the job right the first time protects your investment, saves massive workshop labor fees, and guarantees a quiet, smooth ride!
🧰 What Else You'll Need:
• Safety First: Never work under a vehicle supported only by a jack. Always secure it on heavy-duty safety jack stands.
• Brake Dust Protection: Brakes get incredibly dirty. Keep a pack of Nitrile Gloves handy to protect your hands from stubborn brake dust.
• Clean and Prep: Use a high-quality Brake Cleaner spray to blast away stubborn dust, oil, and road grime from the caliper assembly and new rotors before reassembly.
• Lubrication: Apply a thin smear of high-temperature caliper grease to the pad backing plates and slide pins (keep it off the pad friction material!) to prevent squeals and ensure smooth caliper operation.