CARFIX

TRW Brake Rotor 218mm x 9 Min DF3080S

TRW · Part number DF3080S · NZ$95.00 incl. GST

TRW Brake Rotor 218mm x 9 Min by TRW, part number DF3080S.

Price

NZ$95.00 including GST. Part number DF3080S.

Fits these vehicles

Description

Swapping Out Those Disc Brake Rotors on Yer 'Yota — TRW Style
> Disc brake rotors are the unsung heroes of your Toyota Corolla's braking. They take a hammering and wear down over time. If they get too thin, warped, or cracked (especially with how we drive 'em!), stopping can be a real gamble.

Crikey, What's Gone Wrong?
• Brakes screeches like a banshee when you hit the pedal?
• Steering wheel shakin' like Elvis?
• Takes half a kilometer to pull up?
• Rotors look like they've been attacked by a grinder?

Sweet As, Will it Pass a WOF?
Worn-out rotors are a dead cert for a WOF failure here in NZ. They gotta be above the minimum thickness and not look like a relief map of the Southern Alps to get the tick.

Chuck it in the Garage, or Take it to a Pro?
Difficulty: 6/10 (Tricky, but doable with a bit of elbow grease)
Estimated Time: 2-3 hours per axle (allow a cafe lunch break)
Gear You'll Need: Jack and stands (never get under a car supported only by a jack!), lug wrench, socket set, torque wrench, and some brake cleaner. A caliper tool might be handy too.

🛠️ Bob's "Get It Done Right" Companion Checklist
Before you even think about cracking those nuts, grab these essentials to make the job safer and cleaner:
• Safety First, Mate!: Get yourself some Safety Glasses to keep the brake dust out of your peepers, and a pair of Nitrile Gloves to protect your hands from the grime.
• Brake Dust Be Gone!: Those rotors and calipers will be covered in nasty brake dust. Give 'em a good blast with some Brake Cleaner before you start pulling things apart. Makes life easier, trust me.
• Copper Anti-Seize: When you're putting the calipers back together, use a tiny bit of copper anti-seize on the bolts. This will stop them from welding themselves together next time you need to get in there.

Bob's Two Cents
Worn rotors are a recipe for disaster. Replacing them keeps your Corolla stopping like it should and stops other brake bits from getting buggered. Pop into Bob's Shop and we'll get you sorted with the right gear for your 'Yota. Let's yarn about those parts!

Fitment Notes
Double-check this rotor fits your specific 1974-1980 Corolla. Rotor diameter and thickness must match what you had before. Best to do both front or both rear rotors at the same time for even braking. Bob's your uncle!

---

🛠️ Bob's Pro Tip: Do the Job Right!
> Check out our compatible brake pads (part RDB87) to ensure a perfect bed-in and get the job done properly first time!

🧰 What Else You'll Need:
• Safety First: Never work under a vehicle supported only by a jack. Always secure it on heavy-duty safety jack stands.
• Brake Dust Protection: Keep a pack of Nitrile Gloves handy to protect your hands from grease and dust.
• Clean and Prep: Use Brake Cleaner to clean the anti-corrosion shipping oil off the new rotors before mounting the calipers.
• Lubrication: Apply caliper grease to caliper slide pins and pad contact points to prevent squealing.